Laguna CNC IQ Vacuum Pod System

(No reviews yet) Write a Review
IQ Vacuum Pod System

You can make your own vacuum table, just fasten these down to your bench or a board.

We have supplied general manufacturers, guitar manufacturers, CNC shops, cabinet shops, hobbyist, and all kinds of wood shops for their clamping needs. Cabinet installers use these by screwing them to a board with a level and they vacuum attach to the wall. You then can hold your cabinet in place resting on the board while attaching the cabinet to the wall. These can be attached to the work area of any of our CNC machine. These can also be attached to a workbench so you can use a router on your work piece, sand or shave the surface of your work piece. Also included is a vacuum generator (venturi) and airline fitting so all you have to do is attach to the airline from your compressor and you are ready to go!
  • Each disk is 2 1/2" in diameter and accepts 1/4" supplied tubing
  • 4 Clear Vacuum Clamps
  • 6 Feet of Vacuum Hose
  • 1 Terminating Rubber Hose Cap